FUXTEC BV240 Mode D'emploi page 39

4. Stand behind the device, grasp the brake lever, and hold it against the lower handle.
(Fig.7C)
5. Hold the brake lever as shown in Fig.7C and quickly pull up the starter handle, as shown in
Fig.7D. After starting the engine, slowly return it to the cable guide pins.
6. Set the throttle lever to the "On" position. (Fig.7F)
NOTE! If the cutting unit comes into contact with the ground, the device may move jerkily.
Fig.7A Fig.7B Fig.7C
Fig.7D Fig.7E
Original manual FX-BV240_de_en_fr_ita_es_rev01
Carburetor lever
Throttle lever
40
Grasp the brake
lever.