Publicité
Les langues disponibles
Les langues disponibles
SAFETY INSTRUCTIONS
•
Only intended for indoor use.
•
Do not connect the product to the mains
when it is still in the pack.
•
Do not look directly into the light source.
•
Do not store the product in a damp or
very cold/hot place, this can damage the
electronics.
•
The electronics in the product are sensitive
to knocks and blows. Avoid dropping it.
•
No parts of the product can be replaced,
or repaired. The whole product must be
discarded if any part is damaged.
•
The power cord on this product is not
replaceable, if damaged discard the
complete product.
•
Do not use the product in a bathroom,
or in damp or wet areas.
•
The light source is not replaceable.
Discard the product if the light source
stops working.
•
Switch off the product before cleaning.
•
Do not touch the power cord or the plug
with wet hands or wet parts of your body.
SYMBOLS
Read the instructions.
Only intended for indoor use.
Class II
Non-replaceable light source.
Non-replaceable actuator.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
Output
Luminous flux
Colour temperature
Diffusion angle
Life span
Off/On
Safety class
Energi class
This product contains a light source with
energy efficiency class F.
Protection rating
INSTALLATION
See figure for installation instructions.
FIG. 1
USE
1.
Plug the plug into the power point.
2.
Press the switch to switch on the light.
3.
Press the switch to switch off the light.
DISMANTLING
1.
Remove the top cover with a screwdriver.
2.
Undo the 2 screws on the sides.
3.
Release the soldered wire by melting the
solder with a soldering iron.
4.
Remove the aluminium cover with a
screwdriver.
5.
Release the soldered wire by melting the
solder with a soldering iron.
6.
Done!
EN
230 V ~ 50 Hz
4 W
320 lm
3000 K
80°
30000 h
15000 times
II
IP20
7
Publicité
