Z-Finity™ Footrest System - Quickie Q2 Lite Mode D'emploi

Q UIC KIE 2 L ITE
P. Z-FINITY™ FOOTREST SYSTEM
CAUTION– The Z-FINITY Footrest system is rated to 165lbs (75kg)
™
The footrest position is key to keeping the body in the proper alignment, and providing a stable support
for your legs and torso. Make sure that your Sunrise dealer has correctly adjusted your footrests and/or
legrests with the advice of a healthcare professional. The original setup should not be changed without
first checking with that advisor. Legrests and footrests should be swung out of the way, or removed for
transfers.
NOTE – Footplate must have at least 2 inches of clearance between the footplate and the ground to
prevent hitting obstacles and risking a fall or tip-over.
1. Footrest/Footplate positioning using the rotational clamp
a. Loosen the two rotational/Angle clamp screws (D).
b. Rotate the footrest/ footplate until the desired position and angle is achieved.
c. Tighten the Clamp hardware to proper torque (DO NOT EXCEED a 120 in-lb Max torque).
2. Footrest positioning using footplate spacers
a. Remove footplate spacers (E).
b. Slide footplate to desired depth position.
c. Replace footplate spacers.
3. Height range adjustment (Direct Mount Footrest)
a. Adjust the footplate mounting position by removing the button head screw from the adjustment
hole and moving the assembly to the desired position.
b. Tighten hardware to proper torque (120 in-lb Max).
4. Height range adjustment (Extension Mount Footrest)
a. Loosen set screw (F).
b. Slide footrest extension tube up or down inside frame tube to desired height.
c. Tighten set screw to proper torque (120 in-lb).
MK-100071 Rev. E
53 54 55
26
IX. DEALER SERVICE AND ADJUSTMENT
D
53
54
55