M.swing-In, Swing-Out Hangers And Footrests; Angle Adjustable Footplates; O.platform And Auto-Fold Footrests - Quickie Q2 Lite Mode D'emploi

Q UI C KI E 2 L ITE
M. SWING-IN/SWING-OUT HANGERS AND FOOTRESTS
(70º, 80°)
1. Height Adjustment
NOTE– It is recommended that you maintain a minimum of 2.0 inches between the lowest point on the
footrest and the floor.
a. Loosen set screw (B) using a 3/16 inch hex key.
b. Slide footrest extension up or down inside frame tube to desired height.
c. Tighten set screw. Use a torque setting of 144 in-lbs (16.27 Nm).
N. ANGLE ADJUSTABLE FOOTPLATES
1. Composite Angle Adjustable Footplates
a. Remove bolt (C)
b. Pull footplate section (D) away from extension.
c. Reposition footplate back onto extension in new angular position. Use premarked extension
coupling (E) as guide.
2. Aluminum Angle Adjustable Footplate
a. Loosen screws (G).
b. Adjust footplate (F) to desired angular position.
c. Re-tighten screws (G).
O. PLATFORM AND AUTO-FOLD FOOTRESTS
1. Platform Footrest Height adjustment
a. Loosen the set screw (H) on both sides of the chair.
b. Adjust the Footrest assembly up or down, making sure there is at least 2 inches between the Footrest
and the floor.
48
49 50
51 52
25
IX. DEALER SERVICE AND ADJUSTMENT
48
49
50
51
H
52
H
MK-100071 Rev. E