Bosch NGM5056UC Manuel D'installation page 15

<notes> NoLang
The cooktop comes with an extra burner cap.
▯
The A/A burner cap is for an auxilary burner. It can be
▯
replaced with the OptiSim® burner cap. See
instructions under OptiSim® Burner Cap Placement
for proper location and correct installation.
The OptiSim® has been designed to work with the small
burner located in the rear position of the cooktop and is
used to provide optimal simmering for delicate sauces
while minimizing the risk of scorching.
OptiSim® Burner Cap Placement
30" 4 Burner
30" 5 Burner
36" 5 Burner
OptiSim® Burner Cap Installation
When properly installed the cap will extend beyond the
burner base and raised surface.
Install Burner Grates
Properly position and install each burner grate as shown
in the illustration below.
30" 4 Burner
30" 5 Burner
36" 5 Burner
WARNING
9
To prevent flare-ups, properly support pots and
avoid spills, all grates must be properly positioned
on the cooktop whenever the cooktop is in use.
Each of the four feet must be placed into the
corresponding dimples in the cooktop. Do not use a
grate if the rubber feet are missing or damaged.
For replacement of rubber feet: Call Customer Support
at 1-800-944-2904.
15