Publicité
Les langues disponibles
Les langues disponibles
A Igniter
B Burner Cap
C Burner Base
D Jet Holder
Panhead Screw
E
The burner caps must be properly placed for the cooktop
to function properly. If the burner cap is not properly
placed, one or more of the following problems may
occur:
Burner flames are too high.
▯
Burner flames extend too far on sides.
▯
Stainless steel discolors.
▯
Burners do not ignite.
▯
Burner flames light unevenly.
▯
Burner emits gas odor.
▯
12
Correct Burner Cap Placement
Incorrect Burner Cap Placement
Burner Base and Burner Cap Placement
After electrical connection is complete, place each
▯
burner base on the corresponding location on the
cooktop.
Pay special attention to avoid damaging the igniter
▯
during installation of the base.
The small hole or cutout near the edge should also
▯
line up with the igniter.
Once each burner base is located and resting evenly,
▯
place each burner cap on its correct burner base.
Publicité
