Intended Use - Conrad renkforce Show Design 2 DMX Notice D'emploi

3. Intended Use

The DMX controller is meant for controlling DMX effect lights and similar devices with a DMX control in
light show systems, party rooms, etc..
This product must only be supplied with power by the included mains unit. The mains unit is only approved
for connection to mains sockets with 100-240 V / 50/60 Hz alternate voltage of the public mains grid.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
Any use other than that described above will damage this product and involves the risk of short circuit,
fire, electric shock, etc.
The entire product must not be modified or converted, and the casing must not be opened.
Observe all safety information in these operating instructions!
4. Symbols
This symbol on the device indicates that the user must read these operating instructions before
using the product and observe them during operation.
The symbol with a lightning bolt in a triangle is used where there is a health hazard, e.g. from
electric shock. The device contains no parts that require servicing by the user. Therefore, never
open the device.
The exclamation mark indicates important notes in these operating instructions that must be
strictly observed.
The arrow symbol indicates special advice and operating information.
This symbol indicates that the product must only be used indoors.
34