System Settings; Menu Operation; Explanation Of The Individual Menu Items - Conrad renkforce Show Design 2 DMX Notice D'emploi

15. System Settings

a) Menu Operation
• Push the MENUS/ESC (5) button for approx. two seconds to get to the menu.
• The menu consists of the following items, which are explained in more detail below:
01. Patch fixture:
02. Reset factory:
03. Delete all Fixture patch:
04. Fade mode:
05. RDM DMX Address setup: Identification and addressing of RDM devices
06. Data backup:
07. Data load:
08. Send fixture Update file:
09. Black-out mode:
• Turn the dial switch PAN (11) to navigate the menu.
• Push the REC/ENTER (4) button to select a menu item.
• Turn the dial switch PAN (11) to change the settings. Confirm these changes with the REC/ENTER (4)
button.
• Push the MENUS/ESC (5) button to jump back to the main level and cancel setting.
• Push the MENUS/ESC (5) button for approx. two seconds to leave the menu again and save the
settings.
b) Explanation of the Individual Menu Items
01. Patch fixture
This menu item has already been explained in „Addressing and Basic Settings".
02. Reset factory
This menu item resets the device to factory settings.
Choose this function if the device can no longer be operated or if other malfunctions occur.
• Turn the dial switch PAN (11) until the above menu item appears in the display (12).
• Push the REC/ENTER (4) button.
• Use the dial switch PAN (11) to select [YES] and push the REC/ENTER (4) button again.
DMX-configuration
Restoring the factory settings
Deletes all adjustment settings of the effect lights
Setting the fade times
Storage of the data on a USB drive
Loading of the data from a USB drive
Function not available
Settings for the black-out function
53