Assembly; Fit The Wheel Kit; Secure The Stand - Husqvarna DS150 Manuel D'utilisation

Fit the wheel kit

• Fit the wheel set to the carriage column.
• Fit the wheel set to the bracket on the rear of the
baseplate and tighten the screws.

Secure the stand

There are three methods for fixing the stand.
• Securing with vacuum plate
• Fixing with expander or anchor
• Fixing with threaded rod, washer and lock nut
Securing with vacuum plate
WARNING! The vacuum plate must never be
!
used for ceiling or wall drilling. Careless or
incorrect use can result in serious, even
fatal injury.
If the vacuum plate is used, make sure the
support surface is not porous and can
loosen from the floor or the wall. Make sure
that the vacuum pump has sufficient power
to secure the vacuum plate.
• Fit the vacuum gasket to the baseplate.
• Connect the vacuum pump to the quick coupling for
vacuum pressure on the baseplate.
• Place the bottom plate in the desired position.
• Switch on the vacuum pump. A minimum pressure of 635
mm Hg (25 inch Hg) must be reached for the baseplate to
seal tightly against a surface.
10 –
English

ASSEMBLY

Fixing with expander or anchor
!
DS150
• Drill a hole for the expander/anchor at a distance of 293
mm (11.5") from the center of the hole.
• Screw the baseplate tight. Check carefully that the
expander is secured correctly.
• The bottom plate can be adjusted to the surface by using
the leveling adjustment screws. Use the feed handle.
DS250, DS250 Single speed
• Drill a hole for the expander/anchor at a distance of 300
mm (11,8") from the centre of the hole. The distance of
300 mm (11.8") applies to the quick mounting bracket with
quick coupling for a DM220. With a collar fitted, the
distance is 320 mm (12.6").
300 mm
(13,2")
• Screw the baseplate tight. Check carefully that the
expander is secured correctly.
• The bottom plate can be adjusted to the surface by using
the leveling adjustment screws. Use the feed handle.
IMPORTANT! When drilling roofs, only
expander or anchor suitable for surfaces
exposed to tensile forces should be used.
Use only expander or anchor which is
approved for current application.