Assembly; Fitting The J-Handle; Fitting The Suspension Ring; Fitting The Blade Guard/Combination Guard, Grass Blade And Grass Cutter - Husqvarna 125L Manuel D'utilisation

Fitting the J-handle

WARNING! Only grass blades/grass cutters
!
or trimmer heads/plastic blades may be used
when the J-handle is fitted. Saw blades must
never be used with the J-handle.
• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Fit the bolt, securing plate and wing nut as shown in the
diagram.
• Attach the J-handle to the loop handle using the two
screws, as shown.
• Make a final adjustment of the J-handle to give a
comfortable working position. Tighten the knob.

Fitting the suspension ring

Fit the suspension ring between the rear handle and the loop
handle. Position the hanging ring so that the machine is
balanced and comfortable to work with.
Fitting the blade guard/combination
guard, grass blade and grass cutter
• Hook the blade guard/combination guard (A) onto the
fitting on the shaft and secure with the bolt. CAUTION!
Use the recommended blade guard. See the Technical
data section.
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
30 –
English

ASSEMBLY

• Insert the locking pin (C) in the hole to lock the shaft.
D
A
• Place the blade (D), support cup (E) and support flange
(F) on the output shaft.
• Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool
kit. Hold the shaft of the spanner as close to the blade
guard as possible. To tighten the nut, turn the spanner in
the opposite direction to the direction of rotation (Caution!
left-hand thread).

Assembling the cutting equipment

!
!
G
F
E
B
C
WARNING!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.