cecotec Mambo 7090 Manuel D'instructions page 50

ENGLISH
5. OPERATION
On/off
Use this switch to switch the product on and off.
Start/pause
Fig.20
Press the knob on the product's front part to activate the device.
From the main display, select the desired function.
During the configuration process, hold down the knob for 2 seconds to reset all the settings.
While it is cooking, press the knob to stop it and long-press it for 2 seconds to reset all settings.
After 10 minutes of no operation, the device will enter standby mode.
Once the desired setting or program has been selected, press the knob to activate it and the
device will automatically start operating.
During operation, press the knob to pause the cooking process. The display will show "PAUSE".
You may open the lid, stir or mix ingredients, remove the jar...
Then, place every element back in its correct position and press the knob again to resume
operation. After 10 minutes in pause, the device will automatically turn off.
Use the knob to adjust all settings: time, temperature etc. Turn it clockwise to increase the
value and anticlockwise to decrease it.
Timer
The display shows time as: hour:minutes:seconds.
Press the timer button once, the minute digits will flash. Turn the knob left or right to adjust the
desired minutes. Press it again to switch to seconds, the seconds digits will flash. Press it again
to switch to hours. Turn the knob left or right to adjust the desired hours.
During operation, press the timer button and the device will start counting down automatically.
If the timer has not been set, the product will operate with the preset times:
Heating (without blending): max. 12 hours.
Blending (speed 1-4): max 1 hour.
Beat (speed 5-10): max. 5 mins.
Speed
Press this button to enter speed-setting mode. The speed icon will flash on the display.
Turn the knob left to decrease speed and right to increase it, from level 1 to 10.
If the selected speed is 5-10, the timer will only be set up to 5 minutes. For the rest of the speed
options, 1 hour.
Warning: When speed changes from 5 to 6 or when the device starts working, the device could
emit some noise. This is completely normal and does not affect the device's operation.
To crush or chop hard or large quantities of food, select speed 5 at first and then switch it to 10
to ensure perfect performance.
50