Hitachi CC 14SC Mode D'emploi Et Instructions De Securite page 4

English
10. ALWAYS USE EYE PROTECTION WHEN WORKING WITH THE TOOL, TO PREVENT EYE
INJURY.
Ordinary eyeglasses only have impact resistant lenses, they are NOT safety glasses. Also, use
a face mask for additional safety, and wear a dust mask if the cutting operation produces dust.
11. ALWAYS SECURE THE WORKPIECE TO THE VISE OR THE BASE.
hold the workpiece in place. It's safer than using your hand, and it frees both hands to operate the tool.
12. NEVER OVERREACH.
13. ALWAYS MAINTAIN TOOLS WITH CARE.
performance. Always follow instructions for lubricating the tool and for changing accessories.
14. ALWAYS DISCONNECT THE TOOL
accessories.
15. NEVER RISK UNINTENTIONAL STARTING WHEN PLUGGING IN THE TOOL.
confirm that the switch is in the "OFF" position before inserting the power plug into the receptacle.
16. ALWAYS USE RECOMMENDED ACCESSORIES ONLY, WHEN OPERATING THIS TOOL.
Consult this instruction manual for descriptions of recommended accessories. To avoid personal
injuries, use only recommended accessories in conjunction with this tool.
17. NEVER STAND ON TOOL.
unintentional contact with the cut-off wheel.
18. ALWAYS CHECK FOR DAMAGED PARTS BEFORE USING TOOL.
and all other components for damage before using the tool, to assure that they will function properly.
Check all moving parts for proper alignment, freedom from binding and other conditions that might affect
proper operation. Always repair or replace any damaged guards or other damaged components before
using the tool.
19. NEVER LEAVE THE TOOL RUNNING WHILE UNATTENDED; ALWAYS TURN THE
POWER OFF WHEN THE TOOL IS NOT IN USE.
is not in use. Don't leave tool until it comes to a complete stop.
20.
This tool was not designed to be used for mass-production applications, and should not be used in mass-
production environments.
21.
This tool is intended for residential use only.
22.
When servicing this tool, use only authorized replacement parts.
23.
Apply AC 115 volts only to this tool. Applying the wrong voltage could cause the POWER TOOL to operate
improperly and could cause serious personal injury or damage to the tool.
Specific Safety Rules for Use of this Power Tool
WARNING:
The following specific operating instructions must be observed when using this POWER
TOOL, to avoid injury:
DO's
ALWAYS OBSERVE THE FOLLOWING RULES, TO ASSURE SAFE USE OF THIS TOOL:
1.
Review this Manual and familiarize yourself with the safety rules and operating instructions for this
POWER TOOL, before attempting to use it.
2.
Always confirm that the POWER TOOL is clean, before using it.
3.
Always wear snug-fitting clothing, non-skid footwear (preferably with steel toes) and eye protection,
when operating the POWER TOOL.
4.
Always handle the POWER TOOL carefully. If the POWER TOOL is dropped or struck against a hard object,
it might become deformed or cracked or sustain other damage.
5.
Always cease operating the tool at once, if you notice any abnormality whatsoever.
6.
Always confirm that all components are mounted properly and securely, before using the tool.
7.
When replacing the cut-off wheel, always confirm that the rpm rating of the new wheel is correct for use
on this tool.
8.
Always shut off the power and wait for the cut-off wheel to completely stop rotating, before undertaking
any maintenance or adjustments.
4
Always keep proper footing and balance when working with the tool.
Always keep tools sharp and clean for best and safest
before servicing and before changing cut-off wheels or other
Prevent serious injury by not tipping the tool and by not risking
Use clamps or a vise to
Always check the guard
Always unplug the power cord when the tool
Always