Publicité
Les langues disponibles
Les langues disponibles
Cleaning the spray arms
At regular intervals make sure that the
nozzles in the spray arms are not
blocked. If necessary, clean the nozzles
with a piece of wire or a needle under
running water.
Caution! To prevent damage to the
nozzle openings, clean them carefully.
Ceiling spray arm
1. Turn the fixing screw (A) counterclock-
wise.
2. Pull the spray arm off the shaft.
3. Clean the spray arm and the fixing screw.
4. Attach the spray arm with the fixing screw
by turn it clockwise.
Upper basket spray arm
1. To remove the upper basket spray arm,
turn it laterally.
2. Clean the spray arm.
3. To attach again the spray arm, press up-
wards until it goes back into position.
Lower spray arm
1. Turn the fixing screw B) counterclock-
wise.
2. Pull the spray arm off the shaft.
3. Clean the spray arm and the fixing screw.
4. Attach the spray arm with the fixing screw
by turn it clockwise.
External cleaning
Clean the external surfaces of the appliance
and control panel with a damp soft cloth.
Only use neutral detergents. Do not use
abrasive products, scouring pads or solvents
(acetone, trichloroethylene etc...).
Frost precautions
Caution! Do not install the appliance
where the temperature is below 0 °C.
The manufacturer is not responsible for
damage because of frost.
If not possible, empty the appliance and
close the door. Disconnect the water inlet
hose and remove water from the water inlet
hose.
electrolux 91
Publicité
