Electrolux GA55GLI201 Notice D'utilisation page 78

78 electrolux
1)
Rinse aid
1)
Salt
1) When the salt and/or rinse aid containers are empty, the related indicator lights do not come on while
a washing programme operates.
Programme button
With this button you can select the washing
programme. Press the button, the digital dis-
play shows the programme number. Contin-
ue to press the button until the number of the
necessary programme comes on. Refer to
'Washing programmes' chapter for more da-
ta about the washing programmes.
Half-load button
Important! Set the Half-load option before
the start of a washing programme. You
cannot set the option when a washing
programme operates. If it is necessary to set
the Half-load option, cancel the washing
programme.
The Half-load option is not available for all
washing programmes. Refer to the chapter
'Washing programmes'.
• Load dishes in the upper and lower bas-
ket.
• Decrease the detergent dosage when you
use the Half-load option.
• Press the Half-load button to set the op-
tion.
– The Half-load indicator light comes on,
when the Half-load option is available.
With the Half-load option the time dura-
tion and the consumption of water and
energy are reduced.
Sanitize button
Important! Set the Sanitize option before
the start of a washing programme. You
cannot set the option when a washing
programme operates. If it is necessary to set
the Sanitize option, cancel the washing
programme.
Indicator lights
The indicator light comes on when it is necessary
to fill the rinse aid. Refer to the chapter 'Use of
rinse aid'.
The indicator light comes on when it is necessary
to fill the salt container. Refer to the chapter 'Use
of dishwasher salt'.
After you fill the container, the salt indicator light
can continue to stay on for some hours. This does
not have an unwanted effect on the operation of
the appliance.
This function gives more hygiene to dishes
and glasses. During the last rinse, the tem-
perature increases to 68°C and stays above
65°C minimum for 10 to 14 minutes.
The Sanitize option is not available for all
washing programmes. Refer to the chapter
'Washing programmes'.
Press the Sanitize button to set the function.
The Sanitize indicator light comes on, when
the function is available.
Extra-rinse button
Important! Set the Extra-rinse option before
the start of a washing programme. You
cannot set the option when a washing
programme operates. If it is necessary to set
the Extra-rinse option, cancel the washing
programme.
This function adds one more rinse to the
washing programme.
The Extra-rinse option is not available for all
washing programmes. Refer to the chapter
'Washing programmes'.
Press the Extra-rinse button to set the func-
tion. The Extra-rinse indicator light comes on,
when the function is available.
Multitab button
Press this button to activate/deactivate the
multitab function. Refer to the chapter 'Mul-
titab function'.
Delay start button
Use the delay start button to delay the start
of the washing programme with an interval
between 1 and 19 hours. Refer to the chapter
'Setting and starting a washing programme'.
Digital display
The display shows:
• the set level of the water softener.