Wayscral ANYWAY A2 Notice D'utilisation page 54

Regular checks
Check the tightness of the bolts: lever, crank, pedals, stems.
The tightening torques to be applied are as follows:
COMPONENTS
Pedals on crank arms
Crank arm on bottom bracket
Stem/handlebar tightness
Fork/handlebar tightness
Brake lever
Brake callipers
Seat
Seat post clamp
Wheel
The other tightening torques depend on the size of the nuts: M4: 2.5 to 4.0 Nm, M5: 4.0 to 6.0 Nm,
M6: 6.0 to 7.5 Nm. Tighten the screws evenly to the required torque.
Regularly check the tyres: wear, cuts, cracks, pinching. Replace the tyre if necessary. Check the wheel
rims for excessive wear, warping, denting, cracks, etc.
Servicing
For safety reasons and to keep the components in good working order, you should have your bicycle
regularly serviced by your retailer. Your bicycle should also undergo regular maintenance by a
qualified technician.
First service: 1 month or 300 km
•
Check the components are properly tightened: crank arm, wheel, stem, pedals, stem, seat
clamp,
•
Check the power assistance system is working correctly,
•
Verification and brake adjustment,
•
Tighten and/or straighten the wheels.
•
Tyre pressure
Every year or 2000km:
•
Check the wear levels (brake pads, gear system, tyres),
•
Check the power assistance system is working correctly,
•
Check the bearings (chain set unit, wheels, steering, pedals),
RECOMMENDED TORQUE
(Nm)
30 - 40
30 - 40
6
8
6 – 8
6 – 8
18 – 20
30-40
54
SPECIAL INSTRUCTIONS
Lubricate the threads
Lubricate the threads
Quick clamp
Quick clamp