Wayscral ANYWAY A2 Notice D'utilisation page 47

Tyres
Check tyre pressures regularly. Riding with insufficiently inflated or overinflated tyres can adversely
affect performance, cause premature wear, reduce battery life, or increase the risk of accident.
If there is significant wear or there is a visible groove on one of the tyres, replace it before using the
bicycle. The manufacturer provides a pressure range on the side of the wheel rim and in the following
table. The pressure should be adapted to the weight of the user.
Model
ANYWAY A2
Method for determining the correct adjustment of the quick release mechanisms (wheel and seat
clamp)
The quick release systems are designed to be operated by hand. Never use tools to block or unblock
the mechanism to avoid damaging it.
To adjust the clamping force of the wheel axle, you must use the adjusting nut and not the quick
release lever. If the lever can be operated with minimal manual pressure, it means that it is not
sufficiently tightened. The adjustment nut therefore needs to be tightened. The quick release system
should mark the fork dropouts when closed in the locked position.
Each time an adjustment is carried out, check that the front wheel is correctly centred in relation to
the fork. To adjust, close and open the quick release mechanisms by using the following method:
ADJUSTMENT NUT
Bike size Size of inner tubes
27.5" 27.5 x 2.10
Tyre size
27.5 x 2.10
47
Pressure
PSI Bar
29 – 58 2 - 4
OPEN
CLOSE
D