Kohler K-6505 Guide D'installation page 7

Hex Nut
Spout Base
Hex Nut
Fiber
Washer
Rubber
Washer
Mounting Nut
Spout
Shank
3. Install the Spout
Thread the hex nut down the spout shank.
Slide the O-ring onto the spout shank.
Slip the spout base over the spout shank.
Secure the spout base to the spout shank with the remaining hex
nut.
Set the gasket on the spout base.
Align the spout over the gasket and spout base.
Slide a washer onto each of the four screws.
With the washers in place, secure the spout to the base with the
four screws.
Secure the spout assembly by threading the mounting nut up the
spout shank until snug.
Verify that the spout is level front-to-back and side-to-side. Make
any adjustments as needed.
Kohler Co.
All manuals and user guides at all-guides.com
O-Ring
7
Spout
Gasket
Spout Base
Washer
Screw
1011134-2-B