Sony MEX-M71BT Mode D'emploi page 11

Make sure that
of the unit.
To disconnect by One touch
Touch the N-Mark part of the unit with the
N-Mark part of the smartphone again.
Notes
• When making the connection, handle the
smartphone carefully to prevent scratches.
• One touch connection is not possible when the
unit is already connected to two NFC compatible
devices. In this case, disconnect either device, and
make connection with the smartphone again.
Pairing and connecting with a
BLUETOOTH device
When connecting a BLUETOOTH device for
the first time, mutual registration (called
"pairing") is required. Pairing enables this
unit and other devices to recognize each
other. This unit can connect two BLUETOOTH
devices (two cellular phones, or a cellular
phone and an audio device).
1
Place the BLUETOOTH device within
1 m (3 ft) of this unit.
2
Press MENU, rotate the control dial to
select [BLUETOOTH], then press it.
3
Rotate the control dial to select [SET
PAIRING], then press it.
4
Rotate the control dial to select [SET
DEVICE 1]* or [SET DEVICE 2]*, then
press it.
flashes while the unit is in pairing
standby mode.
* [SET DEVICE 1] or [SET DEVICE 2] will be
changed to the paired device name after
pairing is complete.
5
Perform pairing on the BLUETOOTH
device so it detects this unit.
6
Select [MEX-XXXX] (your model
name) shown in the display of the
BLUETOOTH device.
If your model name does not appear,
repeat from step 2.
lights up on the display
7
If passkey* input is required on the
BLUETOOTH device, input [0000].
* Passkey may be called "Passcode," "PIN code,"
"PIN number" or "Password," etc., depending
on the device.
When pairing is made,
8
Select this unit on the BLUETOOTH
device to establish the BLUETOOTH
connection.
or lights up when the connection is
made.
Note
While connecting to a BLUETOOTH device, this unit
cannot be detected from another device. To enable
detection, enter the pairing mode and search for
this unit from another device.
To start playback
For details, see "Playing a BLUETOOTH
Device" (page 16).
To disconnect the paired device
Perform steps 2 to 4 to disconnect after this
unit and the BLUETOOTH device are paired.
Input passkey
[0000]
stays lit.
11
GB