Hitachi C 7D Instructions De Sécurité Et Mode D'emploi page 8

English
12. WARNING: It is important to support the work piece properly and to hold the saw firmly
to prevent loss of control which could cause personal injury. Fig. 4 illustrates typical hand
support of the saw.
13. Place the wider portion of the saw base on that part of the work piece which is solidly
supported, not on the section that will fall off when the cut is made. As examples, Fig.
5 illustrates the RIGHT way to cut off the end of board, and Fig. 6 the WRONG way. If the
work piece is short or small, clamp is down.
DON'T TRY TO HOLD SHORT PLACES BY HAND!
8
A TYPICAL ILLUSTRATION OF PROPER HAND SUPPORT
AND WORK PIECE SUPPORT.
Fig. 5
Fig. 4
Fig. 6