Kruger KRG 80 HE Manuel D'instructions page 17

M1073-1
Condensate collecting tank
Pic.2 – The tank
The tank is placed behind the front door. It is fitted with a floating
device that stops the dehumidifier when the tank is full.
How to empty the tank
Open the front door and take out the tank as shown on Pic.2 . Use
the sliding open (L) on the top of the tank to flow the water out.
Finally put the tank back into his place and close the front door.
Continuous drainage
The tank is ready to fit the continuous drainage: the installation is
very simple and then you will not need to empty the tank manually
anymore.
To install the continuous drainage follow these instructions (Pic.2):
• remove the rubber stopper (T);
• connect a rubber hose with an internal diameter of 12 millime-
ters to the connenctor on the tank and run it through the hole F
on the bottom of the dehumidifier;
• put the tank back into his place and close the door.
!
ATTENTION: to guarantee regular drainage of
the water, make sure that the drainpipe has a slope
and is straight, without any bends or constrictions.
On any case the floating device inside the tank is
active and will stop the deumidifier when full.
The air filter
The air is placed behind the front grid and can be easily removed for
cleaning. The air filter can be cleaned with a vacuum cleaner or with
water: in this case dry it before assembly.
S
Do not run the dehumidifier without the air filter
to avoid accumulating dust on the heat exchanger.
Keep clean the air filter in particular when al lot of
dust is present in the air: a dirty air filter reduces
the air flow and the efficiency of the dehumidifier.
All manuals and user guides at all-guides.com
How to remove the air filter
Pull the front grid upward: the air filter is behind the grid.
How to put the air filter on
Apply the air filter to the back side of the front grid and insert the
wings (B) into the holes (F) (Pic.4): then fix the grid to the bracket
(S).
ENGLISH
Pic.3 – The air filter
Pic.4 – The air filter assembly
17