Publicité
Les langues disponibles
Les langues disponibles
7.3 Cleaning the Control Panel
• When cleaning the panels with knob-
control, wipe the panel and knobs with a
damp soft cloth and dry with a dry cloth.
Do not remove the knobs and gaskets
underneath to clean the panel. The con-
trol panel and knobs may be damaged.
• While cleaning the inox panels with knob
control, do not use inox cleaning agents
around the knob. The indicators around
the knob can be erased.
• Clean the touch control panels with a
damp soft cloth and dry with a dry cloth.
If your product has a key lock feature, set
the key lock before performing control
panel cleaning. Otherwise, incorrect de-
tection may occur on the keys.
7.4 Cleaning the inside of the oven
(cooking area)
Follow the cleaning steps described in the
"General Cleaning Information" section ac-
cording to the surface types in your oven.
Cleaning the side walls of the oven
The side walls in the cooking area can only
be covered with enamel or catalytic walls.
It varies by model. If there is a catalytic
wall, refer to the "Catalytic surfaces" sec-
tion for information.
If your product is a wire shelf model, re-
move the wire shelves before cleaning the
side walls. Then complete the cleaning as
described in the "General Cleaning Inform-
ation" section according to the side wall
surface type.
To remove the side wire shelves:
1. Remove the front of the wire shelf by
pulling it on the side wall in the oppos-
ite direction.
2. Pull the wire shelf towards you to re-
move it completely.
3. To reattach the shelves, the procedures
applied when removing them must be
repeated from the end to the beginning,
respectively.
7.5 High temperature self-cleaning
The oven is equipped with a pyrolysis fea-
ture. The oven heats up to a temperature
of approximately 420-480 °C and burns
until the existing dirt turns to ash. A strong
smoke may be generated. Provide good
ventilation. High-temperature cleaning
should be performed after approximately
every 10 uses of the oven.
General warnings
Hot surfaces cause burns!
Do not touch the product during
self-cleaning and keep children
away from the product. Wait at
least 30 minutes before removing
the residue.
• Before using the pyrolysis function, re-
move all accessories, the telescopic
shelf and the side shelves (if any). If not
removed, the accessories and side wire
shelves will be damaged.
• If your product has a pyro proof access-
ory (resistant to high temperature self-
cleaning), you do not need to remove
these accessories from the oven.
Whether your accessories are pyro-proof
or not is specified in the accessories
section. If not specified, your accessor-
EN / 32
Publicité
