Installing Updates For The Home Connect Software; Customer Service Access; Deleting Network Settings; Switching The Wifi Connection On Or Off - Bosch B36IT900NP Notice D'utilisation

en-us Alarm
Installing updates for the Home
Connect software
The refrigerator checks at regular intervals whether
updates are available for the Home
Connect software.
The note window appears on the control panel when
an update is available.
To install the update, tap Install now.
Install the update later:
Open the Home Connect menu.
1.
Tap Software update.
2.
This menu is only visible if an update is
Note:
available.
A note window appears.
To install the update, tap Install now.
3.

Customer Service access

If you contact Customer Service, they can access
your appliance and view its status after you have
given your consent. You need to have your
appliance connected to your home network for this.
Further information about Customer Service access
and its availability in your country is available under
www.home-connect.com in the Help & Support area.
Contact Customer Service.
1.
~ "Customer service" on page 23
Confirm the start of Customer Service access in
2.
the app.
During Customer Service access the symbol Ù
appears on the control panel.
As soon as Customer Service has obtained the
3.
necessary data, they end access.
You can interrupt remote diagnosis early by
Note:
switching off Customer Service access in the Home
Connect app.

Deleting network settings

If there is a problem when trying to establish a
connection, or if you would like to register the
appliance in a different home network (WLAN), the
Home Connect settings can be reset.
Open the Home Connect menu on your
1.
refrigerator.
Tap the menu item Reset settings.
2.
Confirm the prompt to delete the network
3.
settings.
To then reconnect the appliance to the home
network, perform initial setup again.
~ "Setting up the connection to the home
network (WLAN)" on page 15
16

Switching the WiFi connection on or off

Open the Home Connect menu on your
1.
refrigerator.
The first time you open the menu, you will be
Note:
automatically guided through initial setup. Follow the
instructions on the control panel.
Select Switch off Wi-Fi.
2.
To start the switching off process, press
3.
Continue.
As soon as the connection to the home network
4.
has been switched off, the message Wi-Fi
switched off will appear. Press OK to confirm the
message.
Note: While the home network connection is
switched off, you will no longer be able to operate
the appliance with your mobile device.

Information on data protection

The first time your Home Connect appliance is
registered on the WLAN network connected to the
Internet, your appliance will transmit the following
types of data to the Home Connect server (initial
registration):
Unique appliance identification (consisting of
■
appliance codes as well as the MAC address of
the installed Wi-Fi communication module).
Security certificate of the WiFi communication
■
module (to ensure a secure data connection).
The current software and hardware version of
■
your domestic appliance.
Status of any previous resetting to factory
■
settings.
This initial registration prepares the Home
Connect functions for use and is only required when
you want to use these Home Connect functions for
the first time.
Note: Please note that the Home Connect functions
can only be utilized with the Home Connect app.
Information on data protection can be called up in
the Home Connect app.
MAlarm
D oor alarm
A l a r m
If the appliance door is open for a long time, the
door alarm (continuous audible signal) switches on.
Close door.
■
The audible warning signal is switched off.