Publicité
LANCE HANGERS AND ADJUSTABLE KIT
Suggested application: Ideal for two-point hanging from areas with high
clearance, such as ceilings or other support structures. Hardware included: 2
lance hangers (and adjustable Gripple kit if upgraded at the time of purchase).
Before you mount the SPYDR module, complete the steps to attach the power
supply to the light bars as outlined in the User Guide . PLEASE NOTE: The
power Supply Enclosure MUST be mounted on the center two light
bars before hanging with the Lance Hanger.
To mount your SPYDR using the lance hangers, place SPYDR fixture gently
1
below the desired hanging area . Identify two points on the structure that
align with center hinges on the SPYDR module .
Hang either the adjustable Hanger kit (if upgraded at time of purchase)
2
or desired hanging hardware to the support structure, above the center
hinges . If using the Adjustable Hanger Kit, first loop the two cables
around the support structure and thread the straight end through the
fixed loop . Then thread each straight end through the Gripple hook and
pull it up the cable .
On the inside of the SPYDR module there are four lancet openings . The
3
lance hanger will slide into the inside-two lancet openings . Place lance
hanger under opening, and gently pull the hanger up from the center of
the hanger until the loops snap into place .
9
Publicité
