Miele A 600 Mode D'emploi page 54

en - Installation
Tools required:
54
Secure the holder in the module
- 9 mm Spanner (WAF 9)
A 805, A 806
The hose for the rinse
attachment at the upper end of
the casing must be connected
to the module water inlet pipe.
A special hose adapter is
required for the rinse connection
on the shaft of the stapler or
instrument. This must also be
connected to the water inlet
pipe.
Two notches are located on the cross rail of the module to which the
holders can be secured.
Push the holder onto one of the notches on the module until it

clicks into place.
Remove the caps from the front side of the water inlet pipe.

Screw the hoses from the holder and the hose adapter (if present)

to the water inlet pipe.
A 807
The two hoses for the rinse
attachments at the upper end of
the casing of the PK™
Dissecting Forceps must be
connected to the module water
inlet pipe.