Miele A 600 Mode D'emploi page 49

At the end
of a programme
Position the shaft of the instrument in the V-shaped recess in the

supporting rail of the A 502 injector unit.
Align the joint at the functional end of the instrument lengthways in

line with the shaft.
Open the functional end of the instrument.

First take the instrument together with the attached hose adapter

out of the holder.
Then detach the hose adapter from the instrument shaft.

Important. Take care as the hose adapter clamp is very strong.
 The hose adapter must be unscrewed and replaced with a blind
stopper if the holder is not in use. Otherwise the loose end of the
hose adapter will be thrown about by the force of the water and
could cause damage.
en - Areas of application
49