KBS 700 Serie Instructions Pour Installation, D'emploi Et Entretien page 33

13 REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS.
• Disconnect the appliance electric supply, if present, before
carrying out any operation.
• After replacing a gas system component, check for gas leaks
at connection points.
• After replacing an electrical system component, check it is
correctly wired.
Replacing the heating element / fan
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the Main Bord / Display board
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Remplacement du thermostat de sécurité
• Remove the control panel.
• Remove the bulb from its seat on the bottom of the hotplate.
• Remove and replace the component.
• Insert the bulb properly in its seat on the bottom of the hotpla-
te.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
14 CLEANING THE INTERIOR
• Check the condition of the inside of the appliance.
• Remove any built-up dirt.
• Check and clean the fumes exhaust system.
15 MAIN COMPONENTS
• Main board
• Display board
• Fan
• Heating element
• Safety thermostat
6