Publicité
Les langues disponibles
Les langues disponibles
Check damaged parts before further use of the hedge trimmer. A guard or other
EN
part that is damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting, and any other condition that
may affect its operation. A guard or other part that is damaged should be properly
repaired or replaced by an authorized service center unless indicated elsewhere
in this manual.
Check the blade and motor mounting bolts at frequent intervals for proper
tightness. Also, visually inspect blade for damage (e.g., bent, cracked, and worn).
Replace the blade only with a blade from EGO
Replace the blade if it is bent or cracked. An unbalanced blade causes vibration
that could damage the motor drive unit or cause personal injury.
If the equipment should start to vibrate abnormally, stop the motor and check
immediately for the cause. Vibration is generally a warning of trouble.
The trimmer shall be used to cut stems less than (22mm) thick.
Trim only in daylight or in good artificial light.
Remove or disconnect battery before servicing, cleaning, or removing material
from the hedge trimmer.
Do not wash with a hose; avoid getting water in motor and electrical connections.
When servicing use only identical replacement parts listed in this manual. Use
of parts which do not meet the original equipment specifications may lead to
improper performance and compromised safety.
Follow instructions for lubricating and changing accessories.
Keep handles dry, clean and free from oil and grease.
Save these instructions. Refer to them frequently and use them to instruct others
who may use this tool. If you loan this tool to someone else, also loan these
instructions to them to prevent misuse of the product and possible injury.
SAVE THESE INSTRUCTIONS!
12
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2400E
All manuals and user guides at all-guides.com
.
TM
INTRODUCTION
Congratulations on your selection of a new generation of 56V Lithium-ion powered
hedge trimmer. It has been designed, engineered and manufactured to give you the
best possible dependability and performance.
Should you experience any problem you cannot easily remedy, please visit the website
egopowerplus.com and select "contact us" or contact the store where you purchased
the item.
This manual contains important information on to the safe assembly, operation and
maintenance of your hedge trimmer. Read it carefully before using the hedge trimmer.
Keep this manual handy so you can refer to it at any time.
SERIAL NUMBER _____________________
YOU SHOULD RECORD BOTH SERIAL NUMBER AND DATE OF PURCHASE AND KEEP IN A SAFE
PLACE FOR FUTURE REFERENCE
SPECIFICATIONS
Voltage
No-Load Speed
Blade Length
Cutting capacity
Weight (Without battery pack, blade guard)
Measured sound power level L
WA
Sound pressure level at operator's position L
Guaranteed sound power level L
WA
(measured according to 2000/14/EC)
Rear handle
Vibration a
h
Front handle
The declared vibration total value has been measured in accordance with a
standard test method and may be used for comparing one tool with another;
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2400E
DATE OF PURCHASE _________________
56 V
1300 /min
61 cm
22 mm
2.79 kg
94 dB(A)
83 dB(A)
K
=2.5 dB(A)
PA
PA
94 dB(A)
1.119 m/s
K=1.5 m/s
2
2
1.761 m/s
2
K=1.5 m/s
2
13
EN
Publicité
