Ego Power+ HT2400E Manuel De L'opérateur page 4

EN
Alternating Current
Direct Current
n No-Load Speed
0
... /min Per Minute
SPM Strokes Per Minute
6
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2400E
All manuals and user guides at all-guides.com
Type of current
Type or a characteristic of current
Rotational speed, at no load
Revolutions per minute
Stroke speed, at no load
GENERAL POWER TOOL SAFETY WARNINGS
WARNING:
Read all safety warnings and instructions. Fail to follow the
warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-operated (corded) power
tool or battery-operated (cordless) power tool.
WORK AREA SAFETY
◾ ◾
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
◾ ◾
Do not operate power tools in explosive atmospheres, such as in the presence
of flammable liquids, gases or dust. Power tools create sparks which may ignite
the dust or fumes.
◾ ◾
Keep children and bystanders away while operating a power tool. Distractions
can cause you to lose control.
ELECTRICAL SAFETY
◾ ◾
Power tool plugs must match the outlet. Never modify the plug in any way. Do
not use any adapter plugs with earthed (grounded) power tools. Unmodified
plugs and matching outlets will reduce risk of electric shock.
◾ ◾
Avoid body contact with earthed or grounded surfaces, such as pipes,
radiators, ranges and refrigerators. There is an increased risk of electric shock if
your body is earthed or grounded.
◾ ◾
Do not expose power tools to rain or wet conditions. Water entering a power
tool will increase the risk of electric shock.
◾ ◾
Do not abuse the cord. Never use the cord for carrying, pulling or unplugging
the power tool. Keep cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of electric shock.
◾ ◾
When operating a power tool outdoors, use an extension cord suitable for outdoor
use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
◾ ◾
If operating a power tool in a damp location is unavoidable, use a residual current
device (RCD) protected supply. Use of an RCD reduces the risk of electric shock.
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2400E
EN
7