Empire Comfort Systems DVCTL60CFP95N Instructions D'installation page 44

MAINTENANCE AND SERVICE (CONT'D)
Maintenance Precautions
Installation and repair should be done by a qualified service person.
The fireplace should be inspected before use and at least annually
by a qualified service person. More frequent cleaning might be
required due to excessive lint from carpeting, bedding material, etc.
It is imperative that control compartments, burners and circulating
air passageways of the fireplace be kept clean.
Keep burner and control compartment clean.
Examine venting system periodically and replace damaged parts.
Make a periodic visual check of pilot and burners. Clean and replace
damaged parts.
Damaged Fireplace
Do not use this fireplace if any part has been under water. Immediately
call a qualified service technician to inspect the fireplace and to
replace any part of the control system and any gas control which
has been under water.
In the event of a natural disaster (tornado, earthquake, fire, etc.)
have a qualified technician inspect the fireplace for damage or
potential gas leaks. Repair or replace any damaged components
before operating this fireplace.
Page 44
FOR INSTALLER
Annual Inspection
• Have the fireplace inspected annually before use.
• More frequent inspection and cleaning may be required if the
fireplace is installed in an area exposed to pet hair or dust, or
to excessive lint from new carpeting or bedding materials.
During The Annual Checkup, The Technician Will:
• Inspect the pilot (flame safety system) and burner(s) for
proper operation and replace any damaged parts.
• Test and measure the flame failure response time of the
flame safety system. It must de-energize the safety shut-off
in no more than 30 seconds.
• Vacuum and clean any foreign debris in the firebox that is
not supposed to be there.
• Inspect and ensure that the lighting of the main burner occurs
within 4 seconds of the gas valve opening. Visual inspection
should match the information illustrated in the manual. Inspect
primary air openings for blockage.
• Check the glass and gasket for proper seal.
• Clean Glass with a suitable fireplace glass cleaner. Abrasive
cleaners must not be used. Be careful not to scratch the glass
when cleaning.
• Check the barrier screen for fit and structural integrity. See
Figure 64.
• Inspect the log set (if applicable) and decorative media (if
applicable) for debris or damage.
• Freshen up the glowing embers if applicable.
• Replace batteries in the remote transmitter and receiver if
applicable.
• Inspect the venting and vent termination cap for damage,
corrosion, sooting, or obstruction and correct if present.
• Check all accessible gas-carrying tubes, connections, pipes
and other components for leaks.
• In addition, clean and inspect the fireplace following any
remodeling work in your home.
43902-0-1021