Empire Comfort Systems DVCTL60CFP95N Instructions D'installation page 13

NOTICE: When installing this
appliance against an exterior wall,
insulate to applicable insulation
codes.
NOTICE: Island and Room Divider
installation is possible as long as
the horizontal portion of the vent
system does not exceed 18 feet with
a minimum vertical run of 8 feet. See
details in Venting Section.
When you install your Direct Vent
Fireplace in room divider or flat on wall
corner positions, maintain a minimum
of 6 inches between the perpendicular
wall and the opening of the appliance.
All wiring should be done by a qualified electrician and shall be in compliance with all local, city and state building codes.
Before making the electrical connection, make sure that the main power supply is disconnected. The appliance, when
installed, must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code ANSI/NFPA 70 (Latest Edition).
Junction Box
A factory-installed junction box is located on the lower right side of
the fireplace. Wiring must be fed to the junction box and attached
with wire nuts to the control module power leads already fed into
the junction box.
Attach black to two black, white to white and power vent. The
ground wire should be attached to the ground on the junction box
and power vent. See Figure 3.
Extend red wire from unit to power vent.
43902-0-1021
LOCATING FIREPLACE
CORNER
INSTALLATION
ANGLED CORNER
INSTALLATION
ELECTRICAL CONSIDERATIONS
COMBUSTION
BLOWER
ISLAND
INSTALLATION
Figure 2
CAUTION
NOTICE: If an auxiliary device is to be used, its wiring may be fed
through the junction box strain relief. Auxiliary device amperage
limit is 5 amps.
NOTICE: A one inch diameter hole should be use to pass wiring
through studs.
JUNCTION BOX CONNECTIONS
RED
(POWER-VENT)
ELECTRICAL POWER TO UNIT
JUNCTION BOX/CONTROL MODULE
COMPONENT
ACCESS BOX
VERTICAL FRAMING MEMBER
Figure 4
CABINET
INSTALLATION
FLUSH WALL
INSTALLATION
ROOM DIVIDER
INSTALLATION
120 VOLT POWER SUPPLY
JUNCTION BOX
BLACK (HOT)
WHITE (NEUTRAL)
GROUND TO JUNCTION BOX
Figure 3
Page 13