Dometic COOLAIR SP950C Instructions De Montage page 6

Warranty
Fit the fastening frame and the compressor unit at the MAN TGL/TGM/TGS as
follows:
1. Insert and tighten the four M8 x 40 bolts, eight washers M8 8.4 x 16 mm, and
four M8 self-locking nuts (fig. 1) in the fastening frame for the compressor unit.
2. Remove the existing nuts (fig. 2 1) from the fastening of the air intake housing.
3. Fasten the fastening frame to the fastening bolts using the three M8 8.4 x 20 mm
washers and three M8 self-locking nuts provided (fig. 2 1).
4. Attach the fastening frame to the bottom of the bracket with the two M8 x 16
bolts, four U-washers M8 8.4 x 20 mm and two M8 self-locking nuts provided
(fig. 2 2).
5. Push the four washers M8 8.4 x 30 mm on the projecting bolts of the fastening
frame (fig. 1 1).
6. Place the compressor unit on the projecting bolts of the fastening frame and bolt
to the four washers M8 8.4 x 16 mm and four M8 self-locking nuts.
7. Check that all bolts are still tight after travelling approximately 200 km.
You find the following steps in the installation manual of the compressor
unit SP950C/SPX1200C.
documents.dometic.com/?object_id=63340
6 Warranty
The statutory warranty period applies. If the product is defective, please contact the
service partner in your country (see dometic.com/dealer).
Our experts will be happy to help you and will discuss the warranty process with you
in more detail.
6
CoolAir SP950C, SPX1200C
EN