Stihl HS 86 Notice D'emploi page 7

English
To reduce the risk of injury, avoid contact
with the cutting blades.
Do not drop start the power tool. The
correct starting procedure is described
in your instruction manual.
Note that the cutting blades continue to
run for a short period after you let go of
the throttle trigger (flywheel effect).
Check the idle speed setting. The cutting
blades must not move when the engine
is idling with the throttle trigger released.
6
All manuals and user guides at all-guides.com
Holding and Controlling the
Machine
Always hold the unit firmly with both
hands on the handles.
Left hand on the control handle, right
hand on the front handle. Wrap your
fingers and thumbs around the handles.
Make sure you always have a secure
footing and operate the machine so that
the cutting blades are always away
from your body.
During Operation
In the event of imminent danger or in an
emergency, switch off the engine
immediately – move the slide control /
stop switch to 0 or STOP.
Check that there are no bystanders in
the general work area.
Observe the cutting blades at all times –
do not cut any areas of the hedge that
you cannot see.
When cutting the top of a taller hedge,
check the other side of the hedge
frequently for bystanders, animals and
obstructions.
Make sure the idle speed setting is
correct. The cutting blades must not run
when the engine is idling with the throttle
trigger released.
Check and correct the idle speed setting
at regular intervals. If the cutting blades
still run, have your dealer check your
machine and make proper adjustments
or repairs.
HS 86 R, HS 86 T