Sony UPX-C21 Mode D'emploi page 20

Preparations
Loading the paper and paper cover
20
Notes
When using ink ribbon cartridge
• Once an ink ribbon cartridge has been completely used, replace it. Ink
ribbon cartridges are not reusable.
• Do not touch the ink ribbon cartridge or place it in a dusty location.
Finger prints or dust on the ink ribbon will result in imperfect printing or
malfunction of the head.
When storing ink ribbon cartridge
• Avoid placing the ink ribbon in a location subject to:
— high temperatures
— high humidity
— excessive dust
— direct sunlight
• Store a partially used ink ribbon cartridge in its original packaging.
If your ink ribbon should tear
Repair the tear with transparent tape. There should be no problem with
using the remaining portion of the ribbon.
Turn the spool in the direction of the arrow
to remove any slack until the transparent
tape cannot be seen.
To load paper, follow the procedure below.
Use the paper tray with appropriate paper size.
Notes
• Use only ink ribbon cartridge and paper that are designed for use with
this printer. Failing to do so is likely to result in unsatisfactory printing
or malfunctions.
• When replacing paper trays or reloading the paper, it is not required to
turn off the power. Turning off the power will cause the image stored in
the memory to be lost.
1
Open the front panel by pulling the front panel top towards you.
2
Push the part marked with PUSH on the paper tray. The paper tray
pops out.
Transparent tape