Cattani ASPI-JET 6 Gamma Manuel D'utilisation page 18

CERTIFICATION OF MEDICAL EQUIPMENT ACCORDING TO DIRECTIVE 93/42/CEE
Further to the accreditation for applying CE marking to those of our appliances that are classified
as medical equipment:
servicing authorized engineers shall use only original CATTANI spare parts when repairing the above
appliances.
This type of intervention (replacement of parts which have lost their mechanical/electric features in
the course of time) is considered as a corrective maintenance intervention on a breakdown with the
purpose to bring the equipment back to its initial safety condition, therefore according to the Directive
93/42 the equipment must be tested again after the intervention.
The tests to be performed are described in the standard IEC EN 62353 "Electromedical equipment"
- Periodic inspections and tests to be performed after interventions on electromedical equipment –
and it is also advisable to perform them as described in the CEI EN 60601-1 (CEI 62-5) standards.
Moreover, with reference to the components listed here below, whose lot and supplier must be easily
traced, engineers shall refer to the following table:
Components
MOTOR UNI-JET 75
PRINTED BOARD
DOOR MICRO SWITCH
ASS. CABLE W/MICRO
While submitting an order for the above components to the sales department of CATTANI S.p.A,
they shall also indicate
of the concerned appliance, committing to install the components to that appliance and not to others.
16
ASPI-JET Models 6-7-8-9
Code
020354 110 V
020348 230 V
020349 240 V
020353 220 V
180921 AC 15 CIRCUIT
180923 AC 15 CIRCUIT
180930 CIRCUIT +pump
180931 CIRCUIT +pump
180940 AC 20 CIRCUIT
180941 AC 20 CIRCUIT
180943 AC 20 CIRCUIT
183102
180810
SERIAL NUMBER
γ
60 Hz
50 Hz
50 Hz
60 Hz
-230 V
-110 V
-220 V
-240 V
-220 V
-240 V
-110 V