Nuova Simonelli Appia Manuel D'instructions page 40

4_Appia1GR_UK.qxp 18-01-2006
7.
PROGRAMMING Appia V
7.1
PROGRAMMING
DOSES
To access the programming units, proceed as
follows:
NOTE: the procedure can be carried out with
the machine on.
• To enter the programming function for each
group, it is necessary to hold down the con-
tinued delivery key
• The delivery keys will begin to flash.
7.2
PROGRAMMING COF-
FEE DOSES
To programme the amount of water for each of
the delivery keys, proceed as follows:
• fill the filter holder with the right amount of
coffee (the double or single filter holder can
be used, according to the key to be pro-
grammed).
• Place the filter holder in the group.
• Press one of the delivery keys:
• The machine will begin to dispense and
once the required quantity has been delive-
red, press the continued key
.
36
All manuals and user guides at all-guides.com
17:33 Pagina 36
• Delivery will cease and the selected dose
key will switch off (the other keys will conti-
nue to flash).
• Press the continued key
the programming function or to continue
programming other dose keys
7.3
PROGRAMMING HOT
WATER
for 5 seconds
• Use the relevant procedure to enter the pro-
gramming function.
• Press the hot water selection key
• Hot water
• Decide the required amount of hot water
and then press the
• Press the continued key
the programming function or to continue
programming other selection keys.
7.4
PROGRAMMING THE
AUTOSTEAM STEAM
NOZZLE (OPTIONAL)
• Use the relevant procedure to enter the pro-
gramming function.
• Insert a jug containing milk and press the
steam key
.
come out of the nozzle.
• When the steam key
the control unit will store the sample tempera-
ture reached in its memory (if the milk tempe-
to exit
7.5
.
delivery will begin.
key again
to exit
NOTE: A time setting of 0 seconds for steam
; this will make steam
is pressed again,
rature reaches the maximum temperature,
steam delivery will be stopped and the maxi-
mum value will remain the setting for the con-
trol unit).
• Press the continued key
the programming function or to continue
programming other selection keys.
PROGRAMMING STAN-
DARD DOSES
• It is possible to enter pre-set values for the
4 group doses and water (steam).
To do this, it is necessary to press the key
and hold it down for at least 10
seconds until the flashing keys switch off.
The doses are:
1CN 2CN 1CL
40 cc 60 cc 50 cc
WATER STEAM TEMP
0 sec.
and water means this function will work
continually.
to exit
2CL
85 cc
50° C