Publicité
Les langues disponibles
Les langues disponibles
WIRING INSTRUCTIONS- two of two
STEP 7: Assemble gear box/impact assembly onto rotor pinion. Be sure
gear box, rotor and stator are firmly and squarely seated in left housing
halve and that the rotor fan has movement.
STEP 9: Install spring plate and speed selector slide into left housing
halve.
STEP 8: Install shuttle onto on-off switch being sure that top switch tab is
captured in the bottom cavity of shuttle. Check for proper shuttle and
switch functionality. Install LED lens into housing halve recess.
Speed selector slide
Spring plate
STEP 10: Check that all elements of electronics assembly are seated
properly and that all wires are pressed completely down in wire traps and
channels.
Carefully install right housing halve-cover onto left housing halve-support.
Watch for pinched wires. Secure with nine housing halve screws.
Check functionality of shuttle and on-off switch (and speed selector slide
on the 2851-20) before installing battery.
Publicité
