Publicité
Les langues disponibles
Les langues disponibles
WIRING INSTRUCTIONS- one of two
Red, white and
black hall sensor wires
(2851-20 only)
STEP 1: Carefully insert rotor into stator. Arrange wires as shown above.
Note the red, white and black wires to the back of PCBA are connected to
the hall sensor, model 2851-20 only. 2850-20 won't have the hall sensor.
STEP 3: Separate and organize wires as shown above. For the 2851-20,
place three hall sensor wires in bottom of housing halve behind on-off
switch cavity. Place black battery terminal wire over those three wires.
STEP 5: Place on-off switch firmly and squarely in cavity of left housing
halve. Be sure all previously placed wires are still captured in properly in
wire traps and channels.
STEP 2: Place rotor/stator and PCBA firmly and squarely in cavities of
left housing halve. Arrange wires as shown above.
STEP 4: Route remaining wires as shown, over the wires from step 3
behind the switch cavity and through the bottom of switch cavity prior to
installing on-off switch.
STEP 6: Place battery terminal block and hall sensor firmly and squarely
in cavity of left housing halve. Be sure to capture hall sensor wires in trap
as shown, model 2851-20 only.
NOTE: The pictured rear bearing
area of housing halve may have
changed in appearance
compared to tool being
serviced. This has no
effect on the wiring of
this tool.
Red, white and black
hall sensor wires
(2851-20 only)
Hall sensor
(2851-20 only)
Publicité
