Toro Flex-Force Power System 60V MAX Manuel D'instructions page 21

5. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator Indicates
light
No battery pack inserted
Off
Green Battery pack is charging
blinking
Green Battery pack is charged
Red Battery pack and/or battery charger is over or under
the appropriate temperature range
Red Battery pack charging fault*
blinking
*Refer to Troubleshooting (page 23)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Service (page 22).
Cleaning the Machine
Cleaning under the Machine
Service Interval: After each use
For best results, clean under the machine soon after
you have completed mowing.
1. Shut off the machine and remove the battery
pack and the safety key.
2. Lower the machine to its lowest cutting-height
setting.
3. Set the machine in the vertical-stow position;
refer to Storing the Machine in the Vertical-Stow
Position (page 20).
4. Using a brush or broom, clean any debris away
from the underside of the machine.
Important:
Do not use water to clean the
machine; water may damage electrical
components.
5. Clean the grass box.
Cleaning the Grass Box
Service Interval: After each use
Frequently clean the grass box to ensure maximum
collection capability. Brush away any debris.
Folding the Handle
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
• If a cable is damaged, contact an
for more
Ensure that the handle is in the operating
position prior to starting the machine to
prevent thrown object related injuries.
1.
2.
3.
1. Vertical-stow position
2. Upright position
4.
19
WARNING
unfolding the handle.
Authorized Service Dealer.
WARNING
Shut off the machine, remove the safety key,
and remove the battery pack; refer to
Off the Machine (page
Pull the handlebar release brace toward the
upper handle to release the handle lock
21).
Fold the handle halfway forward to the upright
position, or fully forward to the vertical-stow
position as shown in
Figure 21
To unfold the handle, refer to
Handle (page 9).
Shutting
17).
(Figure
Figure 21.
3. Operating position
2 Assembling the
g342175