Toro Flex-Force Power System 60V MAX Manuel D'instructions page 16

Recycling the Clippings
Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass box is on the machine, remove it before
recycling the clippings. Refer to
Box (page 16).
Installing the Mulch Plug
1. Shut off the machine and remove the battery
pack and safety key; refer to
Machine (page 17).
2. Place the machine in the vertical stow position;
refer to Storing the Machine in the Vertical-Stow
Position (page 20).
3. Clean the bottom of the deck to ensure the plug
installs properly; refer to
Machine (page 19).
4. Align the mulch plug and push the bottom of the
plug until it snaps into place onto the 2 retaining
pins as shown in
Important:
The bottom of the mulch plug
should be flush with the bottom of the deck
when properly installed; if the mulch plug
does not install correctly, do not use it;
contact your Authorized Service Dealer.
Figure 13
Removing the Mulch Plug
To remove the mulch plug, remove the battery pack
and then reverse the steps in
Plug (page 14).
Removing the Grass
Shutting Off the
Cleaning under the
Figure 13.
Installing the Mulch
g342177
14