Bosch CM10GD Consignes De Fonctionnement/Sécurité page 29

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 29
Using the Workpiece Clamp – This clamp easily
secures a workpiece to the table or base.
1. Insert the clamp's knurled bar down into a clamp
post hole; there are two post holes located in the
base behind the fence. The knurled end must be
in the post at least 1/2".
2. Slide the clamp down until its rubber foot contacts
the workpiece.
3. Adjust the clamp height so it does not touch the
sliding fence.
4. Rotate the clamp's knob until the workpiece is
firmly held in place.
5. Move saw head up and down and forward and
back to be sure it clears the clamp.
WARNING
cannot be used. Support workpiece with your
hand outside the "No Hands" zone. Do not try to
cut short pieces that cannot be clamped and
cause your hand to be in the "No Hands" zone.
Clamp
figure 32. Workpiece Clamp
Clamps – Other hold-down devices such as C-
clamps can be used to hold the workpiece firmly
against the table and the fence. Make sure the
clamps are clear of the cutting path.
WARNING
blade, extend the sliding fences and base
extensions when making extreme bevel, miter or
compound cuts.
preparing for Saw Operations
Workpiece Support
Clamps
There may be extreme
compound cuts where clamp
Workpiece
Sliding fences
To provide sufficient (minimum
6") spacing from hand to saw
Operating Sliding fences
1. Loosen the fence lock knob by turning counter-
clockwise.
2. Slide the fence to the desired position.
3. Lock fence in desired position by turning lock knob
clockwise.
Fence Lock
Knob
Sliding Fence
figure 33
Removing Sliding fences
When performing compound cuts, miter cutting at
extreme bevel angles the fence may need to be
removed.
1. Rotate the fence lock knob counter clockwise seven
rotations.
2. Lift up on fence to remove.
figure 34
29.
Fence Lock
Knob