Sartorius Stedim Biotech CERTOMAT BS-T Mode D'emploi page 87

•
With the keys [F1 to F5] the adjustable parameters of the steps can be selected.
PRSTEP STEP1
ON 0:00
0:00 0:00
STEP3 STEP4
Fig. 15: program definition
For each "STEP" the following parameters can be adjusted (fig. 16):
F1
•
After the pressing of [F1] the input field "SPEED" in speed/min. flashes.
•
In pressing the keys [+/-] the speed is adjusted.
•
Confirm input with [ENTER].
F2
• After the pressing of [F2] the input field "TEMPERATURE" in °C flashes.
•
In pressing the keys [+/-] the temperature is adjusted.
•
Confirm input with [ENTER].
F3
• After the pressing of [F3] the input field "TIME" flashes.
•
In pressing the keys [+/-] the time interval (duration) is adjusted.
•
Confirm input with [ENTER].
•
At the STEP duration values between 00h:01min (immediate change to the next step) and 99h:59min as well as "CONT."
(continuous operation until the manual break with STOP) can be adjusted.
You cannot determine a firm operating time for the PRSTEP. It can only be switched "ON" or "OFF"!
•
PRSTEP in operating mode: the conditions selected in the PRSTEP from the pressing of the [START] key up to the actual program
start [STEP1] are activated.
•
PRSTEP not operating: the shaker, tempering, cooling and light are deactivated until the program start [STEP1].
Function keys
F1-F5
STEP2
0:00
< ESC
PROG1
SPEED: Set-up of the speed
TEMP: Set-up of the temperature
TIME: Set-up of the STEP-duration [h : min]
>
SPEED TEMP
0 10.0°C
OFF
COOLING < - >
Fig. 16: adjustable parameters
TIME
00:00
STEP1
17