Sony VPL-PX40 Mode D'emploi page 26

To control the computer using the supplied Remote Commander
To get the clearest picture
Using the security lock
26
GB
Projecting
Downloaded from:
When you connect an IBM PC/AT compatible to the projector by using the
USB cable, you can control the mouse of the computer using the Remote
Commander.
The R/L CLICK keys and joystick function as follows.
Note
Make sure that nothing obstructs the infrared beam between the Remote Commander
and the remote control detector on the projector.
Key and joystick Function
R CLICK (front) Right button
L CLICK (rear) Left button
Joystick Corresponds with the movements of the mouse
You can adjust picture quality when projecting a signal from the computer.
1
Project a still picture from the computer.
2
Press the APA key.
"Complete!" appears on the screen when the picture is adjusted properly
Notes
• Press the APA key when the full image is displayed on the screen. If the projected
image includes a large black area around the periphery, the APA function will not
function properly and in some cases, portions of the image may not be displayed.
• When you switch the input signal or re-connect a computer, press the APA key again
to adjust the picture again.
• You can cancel the adjustment by pressing the APA key again while "ADJUSTING"
appears on the screen.
• The picture may not be adjusted properly depending on the kinds of input signals.
• Adjust the items in the INPUT SETTING menu when you adjust the picture manually.
1
Press the MENU key and then, in the INSTALL SETTING menu, turn on
the security lock setting.
2
Enter the password.
Use the MENU, M
password. (The default setting is
https://www.usersmanualguide.com/
m < , , and ENTER keys to enter the four-digit
/ / /
ENTER, ENTER, ENTER, ENTER.
"
.
)
"