Publicité
Les langues disponibles
Les langues disponibles
WARNING
Make sure to clean out the ash from the burn pot after each use to ensure the proper function of your pellet grill. Failure to clean out the ash from
fire pot after each use may cause the pellets not to ignite or may cause a build-up of pellet in front of the auger tube potentially causing a burn back
inside auger tube.
WARNING
Always disconnect the electrical cord prior to opening Halo pellet grill for any inspection, cleaning, maintenance or service work. Ensure the unit is
completely cooled to avoid injury.
NO POWER LIGHTS ON THE CONTROLLER
P OS S I BL E C AU SE:
Power Button
■
Not Connected To
■
Power Source, GFCI
Outlet Has Tripped
Faulty controller
■
Battery not placed in
■
unit
PELLETS IN BURN POT WILL NOT LIGHT
P OS S I BL E C AU SE:
Auger not primed
■
Auger motor is jammed
■
Igniter failure
■
SO LU TIO N:
Press the Power Button. Try another attempt and hold for two seconds to verify
■
connection.
Make sure the unit is plugged into a working power source. Reset breaker. Make sure
■
GFCI is a minimum 10 Amp service (see Electrical Wire Diagram for access to electric
components). Ensure all wire connections are firmly connected and dry.
Controller needs to be replaced. Call Consumer Service for a replacement part.
■
Insert the battery if using battery power. Check that the battery is fully charged.
■
SOL UT IO N:
Before the unit is used for the first time or anytime the hopper is completely emptied
■
out, the auger must be primed to allow pellet fill the burn pot. If not primed, the igniter
will timeout before the pellets ignite.
Remove cooking grid and grease plate. Press the Power Button and turn to select Set
■
mode to turn the unit ON and to inspect the auger feed system. Visually confirm that
the auger is dropping pellets into the burn pot. If not operating properly, call Consumer
Service for assistance or a replacement part.
Remove cooking grid and grease plate from cooking chamber. Press the Power Button
■
to turn the unit ON. Turn Control Dial to Set and press to inspect the igniter. Visually
confirm that the igniter is working by seeing the sparks between the two electrodes.
Visually confirm that the igniter gap is approximately 6mm / 0.25 inches in the burn
pot. If not operating properly, follow Manual Start-up Procedure to continue use of
pellet grill. Call Consumer Service for assistance or a replacement part.
35
Publicité
