3. PREPARING THE MACHINE FOR OPERATION
3.1 UNPACKING AND INSPECTING THE CONTENTS
The riding mower is supplied wooden crate cover (1). For transportation reasons some machine assemblies
are disassembled at the production plant and it is necessary to install them before putting the machine
into operation. The unpacking and preparation for operation is performed by the seller within the scope
of the pre-sale service.
- Inspect immediately after delivery that the packed machine has not been damaged. In the
event of damage inform the carrier. If the complaint is not lodged in time, no potential
demands can be claimed.
- Check that the machine model is the same as you ordered. In the event of an irregularity
do not unpack the machine and immediately report this discrepancy to the supplier.
After removing the packaging, carefully remove the riding mower off the pallet. You need to prepare
ramps (2) for this, otherwise there is a risk of damaging parts of the riding mower. Inspect the machine
for damage that may have occurred during transport. Unpack all separately packed assemblies and
inspect them.
1. Crate packaging
2. Ramps
3. Grass catcher
4. Documentation
3.1
5. Seat
6. Steering wheel
The basic package includes:
Riding mower
Steering wheel (6)
Seat (5)
The grass catcher (3) (is partially disassembled in the cardboard box, with a hitch and joining material.
Documentation (4) (packed parts list, user's manual for the riding mower, user's manual for the
engine, user's manual for the battery, service log book)
Ramps (2) are not included with the machine.
3.2 DISPOSAL OF THE PACKAGING
After unpacking the accessories, ensure that the packaging material is properly
disposed of or recycled. The disposal must conform to relevant waste disposal laws
valid in the user's country.
Disposal may be performed by a specialised company.
3.3 ASSEMBLY OF THE SEPARATELY PACKED ASSEMBLIES
Due to the technical nature of this task, the machine is prepared for operation by the vendor
of your riding mower (according to the following instructions).
Before starting the installation, remove all covering protective materials, locate the riding
mower on an even surface and align the front wheels to face forward.
74