CAME BXV SDN4V Manuel D'installation, D'utilisation Et D'entretien page 69

TRAVEL CALIBRATION
 Before calibrating the gate travel, position the gate half-way, check that the maneuvering area is clear of any
obstruction and check that there are mechanical opening and closing stops.
⚠ The mechanical end-stops are obligatory.
Important! When calibrating, all safety devices will be disabled excluding the one for TOTAL STOP which is active
on on the ESC button.
Select A 3.
Press ENTER to confi rm.
Select 1 and press ENTER to confi rm the
travel calibration operation.
The gate will perform a closing maneuver
until it reaches a fi nal stop...
...then the gate will perform an opening
maneuver until it reaches a fi nal stop.
MEMORY ROLL CARD
To memorize user data and confi gure the system, to then reuse them with another control board even on another
system.
 After memorizing the data, it is best to remove the memory roll.
a 3
i
C l i
O P i