Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL CONNECTIONS AND PROGRAMMING
⚠ Warning! Before working on the control panel, cut off the main power supply and, if present, remove any
batteries.
Power supply to the control board and control devices : 24 V AC/ DC.
Functions on the input and output contacts, time adjustments and user-management settings are set and viewed
on the control board's display.
All wiring connections are quick-fuse protected.
Fuses
- Line
- Accessories
DESCRIPTION OF PARTS
1.
Terminal for gearmotors
2.
Terminals for encoders
3.
Terminals for limit-switches
4.
Command and safety devices terminals
5.
Antenna terminal
6.
AF card connector
7.
Memory Roll card connector
8.
R700/R800 board connector
9.
RSE board connector
10. Connector for the RIO-CONN card
11. Display
12. Programming buttons
13. Terminals for paired of CRP connection
14. Terminal board for keypad devices
15. Terminal board for transponder selector
16. Connector for the GSM module
17. Terminals for the RGP1 module
18. Terminals for signaling devices
19. Accessories fuse
20. Terminals for powering the control board
21. Line fuse
22. Power supply terminal board
ZN7V
1.6 A-F
2 A-F
Publicité
