Removing The Protective Cover; Installing The Protective Covers; Camera Skids - Milwaukee 2970-20 Manuel De L'utilisateur

5 Camera Heads and Spring Assembly

5.5.2 Removing the Protective Cover

1. Insert a flat screwdriver into the slot and lift
until the locking tab releases.
2. Place your thumb against the locking tab to
prevent it from falling back into place while
moving to the next tab to unlock it.
3. Remove the top portion of the protective
cover.

5.5.3 Installing the Protective Covers

1. Place the rear half of the protective cover on
the back of the camera head.
2. Twist the camera while pressing down so the
cameras wrench flats line up and lock into
the cover.
3. Line up the protective cover locking tabs and
press the top half into the bottom half. Press
until all the locking tabs have snapped into
place, locking the cover in place.

5.5.4 Camera Skids

There are two skids available for both the 25mm and 34mm camera heads. A small 3"
version and a medium 4" version.
25mm Camera Skids 34mm Camera Skids
66