Screen Rotate; Line Trace - Milwaukee 2970-20 Manuel De L'utilisateur

2 M18™ WIRELESS MONITOR
6. Press the BACK button to exit and return to the main viewing area.

2.3.7 Screen ROTATE

Screen ROTATE – will invert the upright picture 90° with each push of the navigation dial.
This is helpful while using the reel in the horizontal position, and the monitor may not be
in an upright position.
1. Turn the navigation dial to ROTATE
ROTATE option.
2. With each press of the navigation dial, the screen will ROTATE 90° to the right.
CAMERA LIGHT
2019/10/23 01:47:57 AM
2019_10_23_SCREEN
0 Degrees (default)
2019_10_23_SCREEN
180-degree position
Note: The screen will remain in a ROTATE position until it is adjusted back to the default
in this setting.
2.3.8

LINE TRACE

LINE TRACE – activates the internal transmitter to inject a locate signal onto the
push cable. The length of deployed push cable can now be located and traced above
ground with a locator set to the matching LINE TRACE frequency. The M18™ 500GB
CONYTROL HUB must be properly grounded when using the LINE TRACE feature. See
section 3.3.3 in this manual covering the Grounding Post for additional information.
1. Turn the navigation dial to LINE TRACE
2. Turn the navigation dial to select a LINE TRACE frequency of 33kHz or 83kHz and
press the navigation dial.
ROTATE
9.3FT
ROTATE
, press the navigation dial to start the screen
2019_10_23_SCREEN
90 Degree position
2019_10_23_SCREEN
270-degree position
, press the navigation dial.
32
ROTATE
ROTATE