Dometic PerfectView CAM 44 NAV Instructions De Montage Et De Service page 22

Fitting the camera
If you want to screw on the camera with self-tapping screws (fig. f,
page 7)
A
NOTICE!
Self-tapping screws may only be fastened to steel metal with a minimum
thickness of 1.5 mm.
➤ Drill 4 mm diameter holes at the points you just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Stick the double-sided adhesive insulation (fig. 8 5, page 5) to the assembly
side of the bracket.
The insulation plate serves as a seal and protects the paint.
➤ Screw the camera bracket on with the 5 x 20 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted through
the construction (fig. g, page 7)
A
NOTICE!
When tightening the nuts, make sure that they cannot be pulled through
the construction.
You may have to use bigger washers or plates.
➤ Drill 5.5 mm diameter holes at the points you just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Stick the double-sided adhesive insulation (fig. 8 5, page 5) to the assembly
side of the bracket.
The insulation plate serves as a seal and protects the paint.
➤ Screw the camera holder on with the M5 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
22
CAM44
EN