Ecolab DM Modular 20 Mode D'emploi page 71

4.4.3 Rinsing mode
By calling up the "Rinsing mode" function
mode" on page 22, Fig. 5, pos. 4, the display message changes and rinsing can be
started.
Fig. 18: Rinsing mode - schema 1
The "Rinsing mode" is activated by pressing [OK].
Fig. 19: Rinsing mode - schema 2
Before rinsing starts, the remaining cleaning liquid is removed from the mixing container.
If the mixing container is empty, the water valve opens and the mixing container is refilled.
Fig. 20: Rinsing mode - schema 3
If the upper filling level is reached, the rinsing will be started with water.
Fig. 21: Rinsing mode - schema 4
If the level is below the mid filling level, the water valve opens and the mixing
container is filled.
If the middle filling level will be underrun, a counter will be activated. If the middle filling
level not be underun after 5 seconds, the rinsing will be stopped and the mixing container
refilled again. In this case, the water valve will be opened at underrun of the upper filling
level.
41710225´7, 1, en_GB
Control / Visualisation
Ä Chapter 4.4.1 „Beverage
27
Operating level > Rinsing mode
Rev. 03-01.2017